A sewage pump system can offer a lot of benefits. It is responsible for keeping water from the basement when there is flooding or a storm. However, even the best pup requires regular maintenance to operate at its best. It is therefore important that you know how to maintain your pump and pumping station. There are a few simple preventative measures that could be taken to keep your pump and pumping station in perfect condition.
Do routine checks
You should do routine checks of your pump to keep it in its optimal performance state. The pumping system is made of various components. These components should be working properly to ensure that the system functions efficiently. Your pump should be tested regularly. You could do this by pouring clean water into the sump pit to raise the float. Your pump should start to pump the water from the sump pit and shut itself off once the job is done.
During such a test, you should ensure you check that the float can move freely and that all goes on well with your check valve. You should also inspect for foul, mouldyodours. Such odours could indicate that the pump is not running properly or that your pump needs to be cleaned. Another thing you should check is the noise. Whilst all pumps make some noise, you should be aware of any clangs, unusual humming or bangs which could indicate something wrong with your sewage pump rental.
Older pumps may not have been made from corrosion-resistant materials. As a result, if your pump is old, you should check for rust and replace the rusty parts. The most noticeable sign that your sump pump isn’t operating properly is when your basement is full of water.
You should avoid ending up in such a situation as water could cause various damages. Regular inspections are therefore recommended as they will improve the overall efficiency of your pump and contribute to increasing the lifespan of your pump. If there is any problem, you should address it immediately before you end up with a serious problem which could need a replacement.
Regular annual servicing
Annual servicing of your pump system is recommended. The tank of your pump will be emptied to remove blockages. It will be properly cleaned and this will include removing dirt from the sump pit. There will be a lot of dirt and debris to clean, including dirt, gravel and sand.
This highlights the benefits of not disposing of unsuitable things. It is essential to check if there is a blockage in your drainage lines. Servicing will include a check for possible faults, problems or defects which should be addressed.
Replace faulty parts
Since faults are common in every system, your sewage pump system is no exception. Faults will be noticed during servicing or a routine check. Any fault, even if it is minor, should be addressed immediately. When you ignore problems, there is a high chance that the overall performance of your pump will be negatively affected.